General Description: This is a quick drying lacquer stain used on new or stripped wood. It is an excellent product for industrial or household use. It dries fast, will not lap, penetrates well and can be recoated within the hour. FOR INTERIOR USE ONLY.
	Common Usage: Satin Speed Stains can be used on wood paneling, doors, furniture, cabinets, and trim.
	Color: Standard wood tones

Finish Coats: This product can be topcoated by either lacquer, varnish, or polyurethane coatings. Consult your Anchor representative for specific job recommendations.

The surface must be free of all dirt, grease, oil, moisture, or previously applied coatings and finishes before application. The surface should also be sanded to avoid roughness in finish.

	Volume Solids: 5.68% -varies by color
	Drying Time:  Temperature To Touch To Recoat 75 F / 55% R.H. 20 Minutes 1 Hour (Cooler temperatures and higher humidity will lengthen drying time)
	Architectural and Industrial Maintenance Category: Not Intended for Residential use, Shop Use Only.
	Actual V.O.C.: 7.29 lbs./gal. (874 g/l) -varies by color
	Theoretical Coverage: Approximately 500 sq. ft./gallon. Coverage will vary depending on surface texture, porosity and application technique.
	Packaging: When used residentially, these stains are available in quart (1/4 gallon) cans only. However, when used in shop applications, they are available in gallon cans, 5 gallon pails, and 55-gallon drums.
	Storage Temperature: Minimum 20 F Maximum 110 F
	Health & Safety: Refer to the front of this manual, the product label itself, and your Anchor representative concerning a Material Safety Data Sheet for complete information on this product.

	Mixing: Stir thoroughly and frequently during application.
	Thinning: Use Anchor #J-5 Lacquer Thinner.
	Surface Temperature: Minimum 50 F The surface should be dry and the relative humidity should be less than 85%.
	Application Equipment: Airless Spray Pressure: 300-1000 psi Tip: .011"-.015" Conventional Spray Air Pressure: 40-70 psi. Fluid Pressure: 10-20 psi Brush: Use high quality natural china bristle brushes.
	Cleanup: Use Anchor #J-5 Lacquer Thinner.
	Application Considerations: This coating can be applied by brush, spray or by wiping with a white knit cotton rag. Apply in a full wet coat. Coverage will vary due to the porosity of the surface. One coat should suffice, but an additional coat can be applied if a deeper tone is desired. If spraying, follow by wiping off excess with a clean white knit cotton rag. Test color on an inconspicuous area. Color and depth will vary depending on the type of wood.

Limited Warranty:
The technical data on this label or on other data is true and accurate to the best of our knowledge. We guarantee our products to conform to ANCHOR PAINT MFG. CO. quality control standards. Due to misuse in handling, storage, application and workmanship or variables such as weather or surface integrity that are beyond our control, Anchor Paint does not authorize any representative to make any warranty or merchantability of fitness of this product. Any liability whatsoever of Anchor Paint Mfg. Co. to the buyer or user of this product is limited to the purchaser’s cost of the product itself.